problems with speed bleeder.
#1
On The Tree
Thread Starter
iTrader: (8)
Join Date: Jul 2007
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
problems with speed bleeder.
so i got the monster clutch and hyd package from tick performance got it all put in and the line from the speed bleeder to the slave cylinder keeps slowly leaking. its as tight as can be with the washer in the right place.
can i put teflon tape on the treads to maybe seal it?
any suggestions?
can i put teflon tape on the treads to maybe seal it?
any suggestions?
#3
TECH Fanatic
iTrader: (10)
Join Date: Aug 2004
Location: Rochester,Ny
Posts: 1,433
Likes: 0
Received 0 Likes
on
0 Posts
i would not bother with teflon tape.The tape wont stop the high pressure from getting by it.You really need a good seal from the metal/metal contact that the fitting is designed for.I would take it apart and clean it real nice and check out the surfaces on the contact points of the seal area.If they are marked up a lot you might have to change one.and replace the washer