drill mod ?
#1
Teching In
Thread Starter
Join Date: Jan 2011
Location: wesley Chapel fl.
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
drill mod ?
my line is already .118... what do you guys drill it out to... it still had the star washers on the ubolt to the master, so I think it's a virgin but... it looks plenty big compared to the O.D. ... do all yrs. need this mod.?
#2
TECH Fanatic
iTrader: (4)
Join Date: Nov 2001
Location: West Palm Beach, Fl
Posts: 1,066
Likes: 0
Received 11 Likes
on
9 Posts
here is an old "how to" article by install university that gives the drill bit size.
http://www.installuniversity.com/ins...sity/index.htm
http://www.installuniversity.com/ins...sity/index.htm
#3
Teching In
Thread Starter
Join Date: Jan 2011
Location: wesley Chapel fl.
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
here is an old "how to" article by install university that gives the drill bit size.
http://www.installuniversity.com/ins...sity/index.htm
http://www.installuniversity.com/ins...sity/index.htm
I did find this, so i'm good : http://www.chevyhiperformance.com/ho...021/index.html
& this for you new vette guys & yeah I brought it back from the dead https://ls1tech.com/forums/manual-tr...mod-slave.html
Last edited by FLA.SHEE; 01-15-2011 at 08:14 AM.
#4
Teching In
Thread Starter
Join Date: Jan 2011
Location: wesley Chapel fl.
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
I'm glad I didn't put it back together, I didn't realize the restriction was in that far. I saw the large hole in the end & thought I was good. nothing A drill didn't cure!