T56 master cyl. / line question
#1
Launching!
Thread Starter
iTrader: (5)
Join Date: Mar 2005
Location: nw,Il.
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
T56 master cyl. / line question
I have aused clutch master and line that I'm using to mock up the trans in the car I'm building. The line was disconnected from the master when I got it. When I reassemble it with a new roll pin it seems too loose ,like it's not tight enough too seal the o-ring. Here's a picture of what I have. Someone please tell me if I'm missing something.
Thanks
Thanks
#4
12 Second Club
iTrader: (6)
Join Date: Apr 2008
Location: The armpit of the United States.
Posts: 337
Likes: 0
Received 0 Likes
on
0 Posts
I think I read somewhere that there is some kind of black ring, other than the washer, that is suppose to be in there. When I took my M/C apart I didn't notice one, but I didn't try to pull anything out either.
#5
On The Tree
iTrader: (3)
Join Date: Apr 2005
Location: Plainfield, IN
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
There should be an oring in the MC as well as on the line..
Look here for pictures.
http://www.installuniversity.com/ins...r_cylinder.htm
Look here for pictures.
http://www.installuniversity.com/ins...r_cylinder.htm