LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

GM Engineering :/ 1993 T/A trans

Thread Tools
 
Search this Thread
 
Old 05-04-2011, 02:15 PM
  #1  
TECH Apprentice
Thread Starter
iTrader: (4)
 
chevbon's Avatar
 
Join Date: Sep 2009
Location: Delaware
Posts: 326
Likes: 0
Received 0 Likes on 0 Posts
Default GM Engineering :/ 1993 T/A trans
So the car needs a new master cylinder. The hose won't disconnect from either the master or slave, so do I have to buy all 3 pieces? Anybody been through this yet?
chevbon is offline  
Reply Like
Old 05-04-2011, 05:07 PM
  #2  
jmd
TECH Addict
iTrader: (4)
 
jmd's Avatar
 
Join Date: May 2002
Location: T56th Street, Aridzona
Posts: 2,561
Received 26 Likes on 24 Posts

Default
The master has a roll pin through it where the hose end inserts. Slave should too. Push it through and remove the hose.
jmd is offline  
Reply Like
Old 05-06-2011, 02:31 PM
  #3  
TECH Apprentice
Thread Starter
iTrader: (4)
 
chevbon's Avatar
 
Join Date: Sep 2009
Location: Delaware
Posts: 326
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by jmd
The master has a roll pin through it where the hose end inserts. Slave should too. Push it through and remove the hose.
Got it apart. thanks.
chevbon is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
LT1 PP resurface?




Advanced Search

All times are GMT -5. The time now is 11:23 PM.