T56 yoke
Trending Topics
#10
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Feb 2008
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
The yoke I was using is cut. I borrowed it from a local corvette shop and didn't realize it was shorter than stock because I have never seen a stock fbody yoke. I received my new driveshaft today with a normal ~4" yoke and it stopped 2.5" in.
#11
11 Second Club
iTrader: (1)
The yoke will slide until it hits the tailshaft housing. I just ran into this installing a PST driveshaft on my car. You should have 3/4 of an inch of travel with the suspension loaded.
With the suspension hanging the yoke touches the dust boot on the tailshaft seal.
I have a t56 with a 9in.
With the stock set up I had 2.5 in of shaft on spline
With the 9in PST shaft I have 3.5 in of shaft on spline
With the suspension hanging the yoke touches the dust boot on the tailshaft seal.
I have a t56 with a 9in.
With the stock set up I had 2.5 in of shaft on spline
With the 9in PST shaft I have 3.5 in of shaft on spline