LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

help ID a part

Thread Tools
 
Search this Thread
 
Old 04-25-2014, 04:15 PM
  #1  
Teching In
Thread Starter
 
jlwdvm's Avatar
 
Join Date: Mar 2014
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
Default help ID a part
Is this a throwout bearing shim? It came with my Spec Stage 3 clutch set up for my T56 install. Forgive my ignorance...not used to all this new LS-T56 stuff!
Attached Thumbnails help ID a part-002.jpg  
jlwdvm is offline  
Reply Like
Old 04-25-2014, 09:03 PM
  #2  
TECH Addict
iTrader: (14)
 
raven154's Avatar
 
Join Date: Feb 2007
Location: Owasso, OK
Posts: 2,342
Likes: 0
Received 0 Likes on 0 Posts

Default
Yes that is a shim. I would measure the clearance before installing though.
raven154 is offline  
Reply Like
Old 04-26-2014, 09:35 AM
  #3  
Teching In
Thread Starter
 
jlwdvm's Avatar
 
Join Date: Mar 2014
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
Default
If the bolt holes don't line up do I just use the 2 slots?
jlwdvm is offline  
Reply Like
Old 04-27-2014, 08:40 AM
  #4  
TECH Addict
iTrader: (14)
 
raven154's Avatar
 
Join Date: Feb 2007
Location: Owasso, OK
Posts: 2,342
Likes: 0
Received 0 Likes on 0 Posts

Default
It's not going to hurt anything using the slots.
raven154 is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
T56 to a SBC?




Advanced Search
Quick Reply: help ID a part


Reply Closed Thread Share

All times are GMT -5. The time now is 07:10 AM.