ESP68CAMARO

Well this my first post here, unfortunately its not a fun post. I'm a first time forthgen camaro owner. 2000 camaro ls1 t56 car. Yesterday I was driving from first to 2nd I heard a loud clankin noise then the noise settled down but could not get my car to move, every gear like is neutral. Any suggestions? I was thinking clutch but not sure.

mikesimpalass

Can you turn the engine off and put it in gear? Or it just wont go in gear running?

ESP68CAMARO

You can move the shifter in gears but it acts like its in neutral no matter what gear, that's with the engine turned on or off and with out even pushing clutch pedal in.

ESP68CAMARO

I'll try and put a video up.

poltergeist 02

iTrader: (65)

Are you sure it's not the rear end?

ESP68CAMARO

Yes I'm sure

ESP68CAMARO

I'll double check c if its a chewed up ujoint

ESP68CAMARO

U joint looks good

tug686spd

iTrader: (11)

I would double check the rear end. I blew mine last summer and sore up and down it was the tranny. From where it broke at the track between getting it off the track and loading it on trailer then getting into the garage we pushed it probably 100 yards both forward and backwards and it never once made a noise or bound up at all. It was after I had the tranny out and it checked out fine that I decide to check the rear. The car made no noise in forward or reverse.

Old Geezer

iTrader: (3)

There's a trans forum for ?'s such as this.

dr_whigham

iTrader: (49)

Indeed

ESP68CAMARO

K..I won't get my car back till Friday getting tow in from an hour a way. On buissness when it happens.

ESP68CAMARO

Well finally found the time to pop the tranny out, bought a ls7 clutch and other goodies come to find out once the tranny was out the input shaft was broke in half.