Bellhousing and Input shaft question
#1
Teching In
Thread Starter
Join Date: Mar 2014
Location: Melbourne,FL
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Bellhousing and Input shaft question
I'm doing a swap and I was putting the transmission and engine together, I realized installing the bell housing that one of the bolt hole is stripped on it. Should I helicoil it, I don't know if there is enough thread left on it, the thread is all gone. Can I put a longer bolt and nut through it, with locktite red. Or is that a bad idea?
I noticed some surface rust on the input shaft, how should i clean that up? Should any grease be put on it? lithium grease?
Thanks
I noticed some surface rust on the input shaft, how should i clean that up? Should any grease be put on it? lithium grease?
Thanks