Swapping to M6 trans
#1
Teching In
Thread Starter
Join Date: Mar 2014
Location: Frederick, MD
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Swapping to M6 trans
I bought my car a couple of months ago as a roller and it had a manual trans in it. I was going to go auto route but i decided to go back and switch it back to a manual. I have all the holes already cut from the manual being in there before.
Was wondering if i need to get a T56 engine harness or do i modify the one that I have. Also what do i do to make sure the reverse lockout works properly? Have researched a lot about this but it has not be too clear to me.
Any advice on what to do would be much appreciated!
Was wondering if i need to get a T56 engine harness or do i modify the one that I have. Also what do i do to make sure the reverse lockout works properly? Have researched a lot about this but it has not be too clear to me.
Any advice on what to do would be much appreciated!