N/A86

iTrader: (10)

hi, I was told that the viper and srt10 transmissions would require a mid plate and a bellhousing from an fbody trans. why the mid plate? I got an ls bellhousing and it bolted right up to the srt mid plate, is there something else that im not aware of?

jmd

iTrader: (4)

If the pilot fits the bushing / bearing properly and
the spline mates into the disc(s) properly and
The slave depth / mounting differences work for your build,
Then you're good to go.

N/A86

iTrader: (10)

sounds like I have work ahead of me, according to liberty gear the input shaft should work, now with that in mind changing the mid plate wont change where the input shaft sits right? and as far as slave and that I got no clue yet