Kyle Coates

I am doing a t56 conversion in my 99 z28 a4 car. What will I have to do for a neutral safety switch so my car will not be able to crank with out having to push in the clutch? Is the drive shaft from a m6 car and a a4 car the same? Thanks for the input

redbird555

iTrader: (14)

yoou will have to find the 2 wires on the old auto harness that do that and extend them to the switch located on the top of the clutch pedal. i have the details in my writeup on here

Kyle Coates

Ok I'll see if I can find it. I'm new on here I just started my account today

Kyle Coates

I can't find it. Is there any way you could message it to me on here or just post on this thread for me.

chrysler kid

iTrader: (14)

Its at the top oF the page in the manual transmission sticky.

I belive it was the green and purple wires coming out of the a4 shift plug that you run to the switch

stevieturbo

If you are unable to ensure the car is in neutral before attempting to start, you shouldnt have a license.