Do I need an alignment tool? Throw out Bearing?
08-02-2005, 09:46 AM
#1
Teching In
Thread Starter
Join Date: Jun 2005
Location: Atlanta
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Do I need an alignment tool? Throw out Bearing? I just received my GM LS6 Clutch kit, GM Slave, and GM master cylider from Dal at Vandevere. Great transaction BTW.
Three questions:
1. Is that the throw out bearing the the box with the slave cylider?
2. Do I need to get a clutch alignment tool to do the install myself?
3. Is there anything else I should replace while doing the clutch? Like main bearing seal?
Any other advice is appreciated as well.
Thanks,
Seth
Three questions:
1. Is that the throw out bearing the the box with the slave cylider?
2. Do I need to get a clutch alignment tool to do the install myself?
3. Is there anything else I should replace while doing the clutch? Like main bearing seal?
Any other advice is appreciated as well.
Thanks,
Seth
08-02-2005, 02:02 PM
#2
TECH Apprentice
iTrader: (1)
Join Date: Nov 2001
Location: Albuquerque, NM
Posts: 316
Likes: 0
Received 0 Likes
on
0 Posts
1. yes, the throwout bearing should be on the slave
2. yes, you will need an alignment tool (any parts store should have it)
3. that should be all you need to replace
2. yes, you will need an alignment tool (any parts store should have it)
3. that should be all you need to replace
