Slave cylinder broke
12-19-2006, 07:19 PM
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Oct 2006
Location: O HI O
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Slave cylinder broke Ok guys can anyone help me out
About 3 weeks ago i was drive my 99 ta was going back to work and downshifting 4th to 2nd and the clutch pedal stuck to the floor, wouldnt release. I found out that my slave cylinder was shot. i replaced it. i was installing a new clutch (old one was shot) and time came to install the tanny with new slave cylinder then all of a sudden tranny slipped and snapped off the quick connect thats connect the slave cylinder body by the roll pin. I dont want to spend $100 plus for a whole new slave since only one part is broke. Does anyone know where i can get just the individual piece. Or tips on how the rig it to work.
About 3 weeks ago i was drive my 99 ta was going back to work and downshifting 4th to 2nd and the clutch pedal stuck to the floor, wouldnt release. I found out that my slave cylinder was shot. i replaced it. i was installing a new clutch (old one was shot) and time came to install the tanny with new slave cylinder then all of a sudden tranny slipped and snapped off the quick connect thats connect the slave cylinder body by the roll pin. I dont want to spend $100 plus for a whole new slave since only one part is broke. Does anyone know where i can get just the individual piece. Or tips on how the rig it to work.
