Bent clutch slave retainer for MC hose?? (Pictures)
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: Mar 2005
Location: CA
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
Bent clutch slave retainer for MC hose?? (Pictures)
I have a '02 bird with a T56 transmission, and I think I need a new retainer piece that holds the clutch master cylinder hose to the slave coupler. Before I post a wanted ad or bought a new slave cylinder unit just for the piece (they don't sell them separately) I wanted to post and see where my retainer is bent incorrectly, as the clutch hose is popping out. If I could fix it, that would be great.
All the longer prongs are straight up, while the shorter ones are straight, but bent towards the center at a little angle. I think I need to bend little "claws" at the ends of the shorter prongs, as I'm not sure how it's supposed to hold the hose in?
All the longer prongs are straight up, while the shorter ones are straight, but bent towards the center at a little angle. I think I need to bend little "claws" at the ends of the shorter prongs, as I'm not sure how it's supposed to hold the hose in?