Ricks99ls1

iTrader: (9)

Ok i just got my car back after a buddy installed the ls7 clutch kit, new slave and drill mod, i have a few questions, Since this is a new clutch i noticed it engages alot earlier when shifting.... the pedal doesnt quite feel firm, its not spongey, i was told this will firm up as the break in period progresses, and lastly i noticed first gear and reverse, and kinda troublesome to get in, have to pump the clutch a few times to get it to go in, is this normal after installing this and will it get better?

brad8266

iTrader: (23)

They sometimes engage low at first but then get normal after a little bit. Or it may just need more bleeding as well.

bad6as

iTrader: (17)

if it does not get better you might need to bleed it more. hows it doing after you drove it for 2 days

Ricks99ls1

iTrader: (9)

well bud i have only driven it the one time right after i picked it up, i have to run some errands tonigh tim going to take it out and see what happens, why would first and reverse be a pain to engage?

matt3383

iTrader: (3)

Im not sure on the 1st and rev on your but mine has always taken a few secs to get into reverse. 1st gear i have not had a issue with. As far as the clutch engaging off the floor that will adjust itself, it wont move out much but maybe 1-2 inches off the floor. The good thing out these clutches is the ease of the peddle, its just like the stock but with more clamping power in higher rpms