clutch line
10-11-2007, 12:08 PM
#1
TECH Veteran
Thread Starter
iTrader: (14)
clutch line i got a master cylinder for my 414 project off a memeber on here and he had cut the fitting off the end that goes to the slave. and i have been searching for a while to find just the line or even a cheap mastercylinder that has the line but to no avail. in that search a saw someone mention coverting to AN fittings for it. anyone done this and know whats involved and what i need as far as parts (it needs drill mod) and if i can salvage the line i have i will call off my search and buy the fittings
10-12-2007, 08:18 AM
#2
wrencher
iTrader: (2)
Join Date: Aug 2002
Location: Chicagoland
Posts: 4,762
Likes: 0
Received 0 Likes
on
0 Posts
You have to unthread the fitting from the slave & change it out to AN too I believe. That is a difficult feat w/ the trans in.
Looks like a new master would be your easist option.
Looks like a new master would be your easist option.