slayerized6

iTrader: (12)

i know this maybe the stupidest question to ask, but how do you remove the shift ****? im turning it but it doesnt feel like its going anywhere (maybe its stripped ) any and all help would be appreciated

Ericbigmac83

iTrader: (19)

if you stripped it pulling it off then youre superhuman. check for a set screw. is this a stock ****?

slayerized6

iTrader: (12)

yea its a stock. i removed it before, but after i brought it in to get the clutch swapped, it wont come off

PewterScreaminMach

iTrader: (7)

Yeah, if it's stock, you should be able to just crank it counterclockwise until it's loose. Maybe it's just on there really good.

slayerized6

iTrader: (12)

just gave it another shot. i must have given it 100 revolutions counter clockwise and it still feels like it never moved

chuckyt1

iTrader: (33)

The **** probably came loose from the threaded portion. Last time I saw this I think I ended up having to trash the stock ****. Then I was able to twist the the threaded part off.

slayerized6

iTrader: (12)

twisting that shift **** gives me more of a work out than masturbating. i guess ill have to wait for christmas for a new ****

chuckyt1

iTrader: (33)

I feel your pain. Lucky for me I was taking mine off to put a new **** on.

slayerized6

iTrader: (12)

so how do i go about removing the shift **** then. if i try to pull it off couldnt i damage the tranny/shifter?

chuckyt1

iTrader: (33)

Try to peal the leather back from the bottom. You might be able to get it off far enough to grab the threaded part of the **** with some pliers. At least I think that's how I did it, but it has been a while...

2_wacko

iTrader: (2)

Mine was super hard to remove just put some ***** into it.

slayerized6

iTrader: (12)

i finally got it out. thanks for the help guys

Ericbigmac83

iTrader: (19)

What ended up being the problem?

FordGirlGoneBad

iTrader: (1)

I'd like to know too -- I've been trying to get mine off to replace it with a custom glass one and haven't had any luck.

98TADRIVER

iTrader: (36)

i would say the leather wrapped part was loose and that was probably what was spinning. i had the same prob, i just gave it a good GI Joe Kung Fu Grip and took the shifter ball off

I Go To Costco

iTrader: (1)

How did you get it off? I don't know if my shifter stick is jacked up, but I can spin just the rod and the shift **** just spins with it. I also can't get the shift **** off either, it just spins around and around independent of the shift rod.