Final questions about master/slave before I take it in
02-21-2008, 11:30 AM
#1
TECH Apprentice
Thread Starter
iTrader: (4)
Join Date: Oct 2004
Location: Sugar Land, TX
Posts: 394
Likes: 0
Received 0 Likes
on
0 Posts
Final questions about master/slave before I take it in So my clutch is feeling worse every week. It has gotten to the point where under a cold start, the first half of the clutch pedal feels completely free.
I was thinking about buying a GM 01-02 slave and taking it to a tranny shop to have it installed. But people have been telling me to get the master replaced as well. The thing is, if I replace my master, I'd want the McLeod adjustable, and that would empty my wallet. Would I be alright if I just replaced the slave and held off on the master? Replacing the master does not involve taking off the tranny right?
Any other suggestions? Replace the slave and bleed the master (don't know anything about hydros really)?
The clutch is fairly new.
I was thinking about buying a GM 01-02 slave and taking it to a tranny shop to have it installed. But people have been telling me to get the master replaced as well. The thing is, if I replace my master, I'd want the McLeod adjustable, and that would empty my wallet. Would I be alright if I just replaced the slave and held off on the master? Replacing the master does not involve taking off the tranny right?
Any other suggestions? Replace the slave and bleed the master (don't know anything about hydros really)?
The clutch is fairly new.
02-21-2008, 12:46 PM
#2
You would be okay to run a new slave with an old master, but the master may be a problem too. Honestly if you're tapped on funds, I'd do a new master / slave combo (GM) and drill mod it. If bled right, I think you'll be entirely pleased; no McLeod needed.
