Have you? Trans install
#1
Teching In
Thread Starter
Join Date: Mar 2008
Location: TEXAS
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Have you? Trans install
I just put in a spec3 and rebuilt my t56 and when i was puting the trans back in i was having a hard time geting the input shaft to slide in the pilot bearing. So to get some room i put the little sisor jack out of the trunk in between the exaust and the floor and cranked until the back of the engine moved down 1/4 inch about 1 to 1 half turns and the trans slid right in.
Has anyone tryed this before?
Has anyone tryed this before?