Shim needed when using Quick Time bellhousing?
09-13-2008, 08:46 PM
#1
10 Second Club
Thread Starter
iTrader: (1)
Join Date: Jun 2002
Location: Westby, WI
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Shim needed when using Quick Time bellhousing? I'm in the process of installing a Tex Z-grip and a Quick Time bellhousing. The next step is bolting the transmission back into place, which I'm anxious to do, but I'd rather not pull the tranny again just to put a clutch shim in. I don't know why I didn't bother to ask before I tore into it, guess I've just been too damn busy with everything else. Thanks in advance.
