SoundsZ28

iTrader: (6)

i picked up a set of the plastic corvette coil covers and i was wondering how you get them to fit an f-body. Does anybody know how the whole process goes?

SoundsZ28

iTrader: (6)

ttt.... anybody help?

kubus_stroinski

iTrader: (1)

Trim them. I did mine with a dremel and then sanded the edges so that they looked good

This is what mine turned out like

Bad Blue WS6

iTrader: (41)

i hardly cut anything to make them fit,,i have seen some that were really butchered,,esp towards the rear of cover (towards the rear of your engine, or firewall area)which is not nessacary, but im sure not all applications are equal...

Moparnos (The SLP Guy)

iTrader: (55)

this is how i cut mine 4 years ago when i had them. hope it helps

SoundsZ28

iTrader: (6)

thanks for the help, i figured it out for the mostpart but the only problem i had was the driver side with the fuel lines