500rwhp breakin stock driveshaft
#1
500rwhp breakin stock driveshaft
Don't try this at home (or at the track)
500+rwhp
3700bs
MT ET streets
stock diriveshaft
http://home.comcast.net/~craig0628/Atco/Broke_It.wmv
PS I hardly did a burnout thinking the tires would spin a bit allowing me to launch ~3500rpm, guess I was wrong
500+rwhp
3700bs
MT ET streets
stock diriveshaft
http://home.comcast.net/~craig0628/Atco/Broke_It.wmv
PS I hardly did a burnout thinking the tires would spin a bit allowing me to launch ~3500rpm, guess I was wrong
Trending Topics
#11
Thanks guys. I was lucky that a couple local guys (from the board) had a steel driveshaft in my ride within 1/2 hr. I did manage to run an 11.47 @124mph taking it easy. I broke the front yoke on the steel one on my last pass.
If you have a stock d/s and are making ~450+ to the wheels I highly recommend to invest in a good steel d/s with good yokes etc.
If you have a stock d/s and are making ~450+ to the wheels I highly recommend to invest in a good steel d/s with good yokes etc.
#15
TECH Junkie
iTrader: (100)
Originally Posted by cdubbzz
Thanks guys. I was lucky that a couple local guys (from the board) had a steel driveshaft in my ride within 1/2 hr. I did manage to run an 11.47 @124mph taking it easy. I broke the front yoke on the steel one on my last pass.
If you have a stock d/s and are making ~450+ to the wheels I highly recommend to invest in a good steel d/s with good yokes etc.
If you have a stock d/s and are making ~450+ to the wheels I highly recommend to invest in a good steel d/s with good yokes etc.
#17
Originally Posted by ROCNDAV
I have an OEM aluminum with upgraded heavy duty unjoints (1350 int he rear). The guy at the DS shop said the the tube would twist before the yokes ever would. I still think I should get a heavier duty drive shaft
- I broke the rear yoke (stock) trying to launch on the street @ 3.5k
- I twisted the stock driveshaft in 2 pieces at the track @ 3.5k
- I broke a front yoke with a steel driveshaft @ 4k
Needless to say after it broke once I had a BMR d/s loop installed
#20
Originally Posted by 67maro
How do you like those livernois heads?
240 runner
64cc's
2.08 /1.575 valves