Need helpful opinions
#1
Need helpful opinions
Hey guys, it's been a while since if been on here but I need some help. This last summer I snapped my driveshaft on a hard launch and after I replaced it and got it on the road again my crank pulley is rubbing on my from swag bar, could I have bent my kmember? And I can barely get it into reverse anymore and the gears are notchy going in. Any help would be greatly appreciated. Thanks
#3
Yea the flange that bolts to the body is bent down a little bit. And my rear end is not lined correctly. I have a 6.0 iron block with long tubes. What's a good kmember that will hold the weight?