What wire do I tap for injector + and - (aquamist install)
06-12-2015, 10:04 AM
#1
On The Tree
Thread Starter
Join Date: Aug 2014
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
What wire do I tap for injector + and - (aquamist install) here are the 3 wires that i need to connect.
IGNITION SW. (INJECTOR +)
FUEL INJECTOR (-)
MAP SENSOR (0-5V)
http://www.aquamist.co.uk/HFS6/HFS-6-4w.pdf
heres the 1998 pcm pinout
http://www.ls2.com/boggs/torques/98pinpcm.htm
looks like
Blue (pin 48) is for the map signal
or do i tap into pin 64?
but which pin do i use for the injector + and - ? i only see injectors 1-8 neither say + or -
any inputs would be appreciated thanks
IGNITION SW. (INJECTOR +)
FUEL INJECTOR (-)
MAP SENSOR (0-5V)
http://www.aquamist.co.uk/HFS6/HFS-6-4w.pdf
heres the 1998 pcm pinout
http://www.ls2.com/boggs/torques/98pinpcm.htm
looks like
Blue (pin 48) is for the map signal
or do i tap into pin 64?
but which pin do i use for the injector + and - ? i only see injectors 1-8 neither say + or -
any inputs would be appreciated thanks
