Anybody with Lingenfelter LNC-002 and Microedge?
01-04-2010, 02:01 AM
#1
Anybody with Lingenfelter LNC-002 and Microedge? I just bought a Lingenfelter 2-step/timing controller so I can pull timing out when nitrous is activated. Now I was just wondering if anybody has a wiring diagram on how to hook the LNC up with the microedge? I already have the microedge hooked up. Is it a hard piece to install?
01-04-2010, 06:41 PM
#2
Here you go, bro!
http://www.lingenfelter.com/photo/L4...ler%20v1.1.pdf
I just ordered mine today and im excited about getting it installed and ready for Friday night. Are you running Nitrous on yours also? Im curious as to how im going to wire in a relay to keep the nitrous from popping off on the line at WOT and 5000 rpms.
http://www.lingenfelter.com/photo/L4...ler%20v1.1.pdf
I just ordered mine today and im excited about getting it installed and ready for Friday night. Are you running Nitrous on yours also? Im curious as to how im going to wire in a relay to keep the nitrous from popping off on the line at WOT and 5000 rpms.
01-04-2010, 11:29 PM
#3
Here you go, bro!
http://www.lingenfelter.com/photo/L4...ler%20v1.1.pdf
I just ordered mine today and im excited about getting it installed and ready for Friday night. Are you running Nitrous on yours also? Im curious as to how im going to wire in a relay to keep the nitrous from popping off on the line at WOT and 5000 rpms.
http://www.lingenfelter.com/photo/L4...ler%20v1.1.pdf
I just ordered mine today and im excited about getting it installed and ready for Friday night. Are you running Nitrous on yours also? Im curious as to how im going to wire in a relay to keep the nitrous from popping off on the line at WOT and 5000 rpms.
