sofla71chev

iTrader: (5)

I am running an edelbrock victor jr with a edelbrock performer rpm nitrous carb plate. I can't find info on jet sizes for this for anything but 5.5psi fuel pressure. I am going to be running around 55psi to the plate.

Do any of you nitrous guru's know a good starting point for jetting , or is there a calculator somewhere that can be used. The edelbrock paperwork says: 55/61 100hp , 71/75 150hp , 78/82 175hp , 85/89 200hp , 99/102 250hp , all at 5.5psi

Thanks for info in advance

Chris@NitroDaves

Unfortuantely you are going to have to call Edelbrock and get the jetting for the plate at the fuel pressure.

JRracing

iTrader: (35)

I would run the fuel line through a low psi reg before the plate to bring it down to the level it was designed to be sprayed at. Just my opinion..

JRracing

iTrader: (35)

I'm putting the same plate kit on my 383 right now. I am running a dedicated low psi pump and line to a reg and then into the plate.

jmill96Z

iTrader: (3)

I run my pro flow plate on efi fuel pressure. Not that big of a deal