baezi z06

iTrader: (2)

Hi

can i use a 18ft 4an feed line for +300 shots

single stage plate and itīs one bottle straight line to the noids just a filter and pressure sensor on the line.

thanks
Baezi

87silverbullet

iTrader: (11)

Two words: Hell No!

You need to step up to a -6 an. Usually you want to step up to a 6 at around 225

Chris@NitroDaves

As posted above in order to spray 300+hp you will need to upgrade the line to a 6an version.

hardcore

iTrader: (2)

oops... guess that's my next project

Nitro Dave's Nitrous Outlet

iTrader: (25)

The -4 main feed that long will flow up to about 250hp. The longer the hose the less it can flow. I would swap to 8 an like suggested above.
Dave

87silverbullet

iTrader: (11)

Also check as to what valve you have in your bottle. Make sure you have a good flowing valve to feed that -6 an line and also make sure you have the solenoids that can flow a 300 shot.

baezi z06

iTrader: (2)

i have a nitousoutlet 92mm plate kit whith the bigger noids (for up to 400shots) and a 16ft 4 an line i got whith the kit then there is the filter extension and small extension for the pressure sensor 17-18ft i assume

i have only sprayed .078 jet so far 200-225 shot

so i need to get me a new 6 an hoes bigger fittings/valve for the bottles and new 6an fittings into the noid right




thanks
Baezi

87silverbullet

iTrader: (11)

Yup you got it covered.

magnum-gto

The 18' length is too long, but its OK because the -4 is too small also.

Carter01

iTrader: (11)

Also remember that Dave can cut the line any length you want. So the shorter the better.

When i went from 250 to 300 I switched to a -6 from a -4 and shortened the line.

baezi z06

iTrader: (2)

Thanks guys

PONTIAC SLP

iTrader: (3)

The answer is no should run with 6AN line , But we sprayed 300rwhp on 4AN line but i say 6AN is better .