Stock bottom 5.3 best plate setup?
#1
Stock bottom 5.3 best plate setup?
I'm putting together a 5.3 ,stock bottom end.will be doing rings rods mains.stock pistons,they are dished.the heads are 706 mild port job,victor jr or gm single plane .750 vacuum sec.carb .eldelbrock 2216 cam.4000 stall ,3.73 rear.ok I want to do a 150 shot on it,any recommendations on brand,plate or port setup? It will have all the necessary fuel system upgrades.it will be in a 3400 lb Chevy truck.th350 trans.looking at nx stuff but it's been about 8 years since I used there stuff.any advice is welcome,thanks.
#2
It sounds like you have your setup good and ready for some nitrous. We do not make plate setups for the Vic Jr but we do spray bar setups in those intakes with great results. Ill send you over a pm with pricing and photos.