LNC 2000 Timing Computer & window switch
#1
11 Second Club
Thread Starter
iTrader: (3)
Join Date: Feb 2010
Location: The Beach
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
LNC 2000 Timing Computer & window switch
Heres my N20 set up... Im pulling 5 degrees of timing only when the Nitrous Activation switch is armed. 100 shot. Window switch turns the nitrous on @ 2800 rpm & off at 5800 rpm before the factory fuel cutoff. My 404 ci Nitrous stroker motor pulls like a 500 ci. Big Block. Installing an innovate wideband air/fuel ratio sensor/Gage next week. Works great !
Attached Thumbnails
Attached Thumbnails
Last edited by NOS LS1; 08-25-2013 at 02:06 PM.
#7
11 Second Club
Thread Starter
iTrader: (3)
Join Date: Feb 2010
Location: The Beach
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Yes i like my gages on the cowl location. Later on the gages will be covered with a 4" cowl induction hood.
This is an ideal location. You can monitor your N20 & Fuel pressure while you make a pass. Gages are just a couple inches away from your line of sight. Monitoring the fuel pressure at full throttle while on the bottle will tell you if you have enough fuel pressure at WOT while on the bottle. Nano system is going in next so i can have stable N20 pressure & monitor that.
This is an ideal location. You can monitor your N20 & Fuel pressure while you make a pass. Gages are just a couple inches away from your line of sight. Monitoring the fuel pressure at full throttle while on the bottle will tell you if you have enough fuel pressure at WOT while on the bottle. Nano system is going in next so i can have stable N20 pressure & monitor that.
Last edited by NOS LS1; 08-26-2013 at 11:29 PM.