dburt86

iTrader: (2)

I purchased a dual nozzle kit from a member on here and I'm looking for suggestions on where to place the nozzles.

This is going to be a 200 wet shot.

Nitrous express suggested that I try to place the nozzles 6 inches from the throttle plate, and I can do that, but I'm worried because my intake takes a hard 90 when it goes into the throttle.

Nitrous express says this is not an issue. I beleive them but just wanted to see how other guys are doing it.

Also, because of how tight the intake is to everything, I'll have to place the nozzles at 12 and 6 O'clock.

Any thoughts on the 90 bend or the 12/6 o'clock position of the Nozzles?

Application-

Rise of the Phoenix

iTrader: (27)

Is there not enough space to put the nozzles in at a 2 o-clock and 10 o-clock position right as the intake starts to straighten out?

dburt86

iTrader: (2)

I probably could. I definetley could do 2 and 12.

I could also put them in the outter radius of the actual rubber coupler at like 9 and 3?

Should I be worried about the fuel condensing on the wall of the 90 as it makes the turn?