Stock bottom end
08-08-2004, 06:52 PM
#1
On The Tree
Thread Starter
Join Date: Jul 2004
Location: Antioch, CA
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Stock bottom end I am going to put in a nice big wet shot of nitrous, mod in sig. I will have either a 12 bolt or 9" and a driveshaft before i get the nitrous, but, will my bottom end hold up, or will i need forged pistons and connecting rods, what about the crank?
I was thinking of 150 shot, maybe 200. Thanks
I was thinking of 150 shot, maybe 200. Thanks
08-08-2004, 08:02 PM
#2
TECH Apprentice
Join Date: Jun 2002
Location: Chester, VA
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
I have the original 2.73's in and 54K miles been spraying since 12K. But it is an auto. M6's tend not to last as long. Crank is good. Pistons and rods "should be" good for a 150+ shot. It is all in the tuning. 200... I would'nt but, know folks that have. Better think about a fuel pump too.
08-08-2004, 08:11 PM
#3
On The Tree
Thread Starter
Join Date: Jul 2004
Location: Antioch, CA
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
I already got 30lb injectors in there, i will upgrade the fuel pump if i do anything over a 100.
I am leaning toward doing something around 150. . .But i still have awhile to decide.
I am leaning toward doing something around 150. . .But i still have awhile to decide.
