Anyone running nitro dave's carb intake elbow?
04-24-2006, 07:23 PM
#1
TECH Junkie
Thread Starter
iTrader: (71)
Join Date: Mar 2002
Location: East Brady, Pa
Posts: 3,703
Likes: 0
Received 0 Likes
on
0 Posts
Anyone running nitro dave's carb intake elbow? Just looking for some feedback from anyone running this setup. Is it possible to drill and tap my nitrous nozzles in this elbow some place? Thanks for any input on your experiences.
04-25-2006, 08:29 AM
#2
TECH Fanatic
iTrader: (12)
Join Date: Nov 2001
Location: The Woodlands, TX
Posts: 1,934
Likes: 0
Received 0 Likes
on
0 Posts
Dave ran it on his own car with good results. Most benefits will come from having a motor requiring a lot of air or spraying large shots of nitrous. Your nozzles can be tapped into the intake if you want or Dave can plumb spray bars into it when you buy it. 
04-25-2006, 07:34 PM
#4
TECH Junkie
Thread Starter
iTrader: (71)
Join Date: Mar 2002
Location: East Brady, Pa
Posts: 3,703
Likes: 0
Received 0 Likes
on
0 Posts
I bought one of dave's elbows second hand and already have a tnt kit....hence my questions. I'd probaby have to send it in to have a couple bungs installed for the nozzles.
04-25-2006, 08:26 PM
#5
Restricted User
iTrader: (9)
Join Date: Sep 2002
Location: Sierra Vista, AZ
Posts: 7,603
Likes: 0
Received 0 Likes
on
0 Posts
I personally think rather than spending the $ on welding in bungs you could spend the $ and buy a plate to sit b/w the intake and elbow, no worries of distribution and no unsightly rigging. Thats what I have been looking at doing, but have a couple things in the works, so holding off.
Charlie
Charlie
