FS: Amp - Rockford Punch 401s 1200w
#1
FS: Amp - Rockford Punch 401s 1200w
SOLD
Retail - 199
I'm not sure what to ask, but it works great last time I had it hooked up. It's just been sitting in my closet, and I don't care to see it just sit around. I'm done with bass. Just needs a bit of cleaning. The bass remote is a very nice feature. Loved it.
I'll ask $125 for it.
* 100 watts RMS x 2 at 4 ohms
* 200 watts RMS x 2 at 2 ohms
* 400 watts RMS x 1 at 4 ohms in bridged mode
* stereo or bridged mono output
* 4-ohm stable in bridged mode
* Tri-Way capable
* requires 8-gauge power and ground leads — wiring and hardware not included with amplifier
* 50-250 Hz high-pass/low-pass (12 dB/octave) crossovers
* wired remote included for fingertip control of Punch Bass (0-18 dB boost at 45 Hz)
* MOSFET power supply and output devices
* MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability
* TOPAZ — noise-killing differential inputs that eliminate 80% of ground loop noise
* Trans•ana circuitry keeps preamp voltages low and signal paths simple for outstanding audio quality
* NOMAD — advanced protection circuitry for "intelligent" shutdown protection
* speaker- and preamp-level inputs
* 11-1/8"W x 2-3/8"H x 9-7/8"D
* 1-year SonicElectronix.com warranty
Retail - 199
I'm not sure what to ask, but it works great last time I had it hooked up. It's just been sitting in my closet, and I don't care to see it just sit around. I'm done with bass. Just needs a bit of cleaning. The bass remote is a very nice feature. Loved it.
I'll ask $125 for it.
* 100 watts RMS x 2 at 4 ohms
* 200 watts RMS x 2 at 2 ohms
* 400 watts RMS x 1 at 4 ohms in bridged mode
* stereo or bridged mono output
* 4-ohm stable in bridged mode
* Tri-Way capable
* requires 8-gauge power and ground leads — wiring and hardware not included with amplifier
* 50-250 Hz high-pass/low-pass (12 dB/octave) crossovers
* wired remote included for fingertip control of Punch Bass (0-18 dB boost at 45 Hz)
* MOSFET power supply and output devices
* MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability
* TOPAZ — noise-killing differential inputs that eliminate 80% of ground loop noise
* Trans•ana circuitry keeps preamp voltages low and signal paths simple for outstanding audio quality
* NOMAD — advanced protection circuitry for "intelligent" shutdown protection
* speaker- and preamp-level inputs
* 11-1/8"W x 2-3/8"H x 9-7/8"D
* 1-year SonicElectronix.com warranty
Last edited by allbaugh_04; 08-05-2010 at 12:45 PM.