Who around here, can mill my heads???
#1
11 Second Club
Thread Starter
iTrader: (19)
Join Date: May 2006
Location: Whidbey Island, Wa.
Posts: 965
Likes: 0
Received 0 Likes
on
0 Posts
Who around here, can mill my heads???
Just like the title says...
Is there someone around here that can do it? And what are there prices, wait time, and phone number?
Lane
Is there someone around here that can do it? And what are there prices, wait time, and phone number?
Lane
#2
TECH Resident
iTrader: (24)
Join Date: Oct 2004
Location: Ft lewis,Ft sill and thats all i hope.Katy texas
Posts: 839
Likes: 0
Received 0 Likes
on
0 Posts
tsp can do it for 75 bucks prob take a week or so......and yes i know not local just an alt choice
Last edited by Ws6man2000; 01-18-2008 at 03:56 PM. Reason: add info
#6
TECH Enthusiast
iTrader: (12)
Lane, just take them to F&S in town. He did mine a while back and they were fine. He repaired one of the valve seats and milled em like .007" to resurface them and only charged me around 100 bucks. He even setup the springs on them afterwards and all for just 100 bucks.
#7
11 Second Club
Thread Starter
iTrader: (19)
Join Date: May 2006
Location: Whidbey Island, Wa.
Posts: 965
Likes: 0
Received 0 Likes
on
0 Posts
Well I just got of the phone with XL8RN, And they are 4.8 heads, He was cleaning them up and seen the casting on them. Witch is fine, I did some research on them, they have a 62cc, and flow the same as a 5.3. So I don't think I am going to mill them.
But I am still going to use Cometics, and go on ahead and fly cut.
My CR should be around 11.1:1. Witch is fine.
But I am still going to use Cometics, and go on ahead and fly cut.
My CR should be around 11.1:1. Witch is fine.