Dual Nitrous Bottle Setup
06-20-2011, 06:37 PM
#1
TECH Junkie
Thread Starter
iTrader: (19)
Join Date: Feb 2005
Location: Sandusky, Ohio
Posts: 3,155
Likes: 0
Received 0 Likes
on
0 Posts
Dual Nitrous Bottle Setup Category: Engine - Power Adders
Price: $1
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): OH
Item Condition: Used
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
Included are:
(2) 15lb NOS Nitrous bottles (both full of nitrous!)
-One has the liquid filled gage, one doesn't
-Both have the Super High Flow Valves
(1) Aerospace Components Nitrous Bottle Billet Brackets
http://www.jegs.com/i/Aerospace-Comp...oductId=750114
(2) NOS electric heaters
(1) Dual gage pillar mount
(1) Auto Meter - Ultra Lite Nitrous Pressure Gage & Electrical Sending Unit
(1) Auto Meter - Ultra Lite Fuel Pressure Gage & Electrical Sending Unit
If bought new:
Bottles - $630
Bracket $301
Heaters - $200
Gages - $450
Total New: $1600+
Asking $1200 OBO Picked up since the bottles are full.
Post for the gages:
Both units work, and are mounted in a dual pod A-pillar mount for a 98-02 car with T-Tops.
Parting out the car so these are next to go.
Auto Meter - Ultra Lite Nitrous Pressure Gage & Electrical Sending Unit
http://www.summitracing.com/parts/ATM-4374/
Auto Meter - Ultra Lite Fuel Pressure Gage & Electrical Sending Unit
http://www.summitracing.com/parts/ATM-4363/
I have swapped out the back light bulbs for red, instead of the factory orange.
I have cut and extended the sending unit lines for the nitrous and fuel pressure lines. I did this for the nitrous, so that you can reach to the trunk onto the bottle, and I did this for the fuel pressure to tap onto the fuel rail. Caused no issues, simple 3 wire setup.
Doing this, also allowed a very small hole to be put in the firewall to the fuel rail, right now, the wires are cut on the fuel sending unit. I can soder these back together if the buyer wishes. I recommend to leave it as it, install it, and soder them back together in the car. This will allow you to drill a small pilot hole, instead of a 1/2" hole for the weatherpak connector to fit through.
Buyer covers Paypal fees. (3%)
Trending Topics
01-15-2012, 08:19 PM
#18
