FASTFATBOY

iTrader: (23)

Category: Engine - Complete Motors
Price: $7500
Part Fits: 93-02 Chevrolet Camaro
Location (State): AL
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LT1/LT4, Small Block
LS Engine?: Non-LS Part

I know this is a for sale thread, but the ones interested are in here. This was my Dad's engine, he passed away a year ago or so.

ALL PARTS NEW UNLESS OTHERWISE SPECIFIED, SHIPPING NOT INCLUDED.

This setup with a turbo, spray or blower can make over 1000 HP easily, I am never going to finish it.

LT1 block, modified by LSM Systems Engineering it's ready to assemble, almost $3,000 in machine work, Pro-Gram billet main caps, ARP studs, clearanced for 383, roller cam bearings, oil system modified to street drive this setup, zero deck. Have receipts for LSM's machine work, was $2200 I think, it had $500 worth done before it went to them. ** PLEASE READ BELOW ABOUT THIS BLOCK**

LSM Systems Engineering solid roller cam for this setup, originally setup for spray but the cam will work well with any power adder.

LOBE LIFT, multiply by rocker ratio to get gross lift. INTAKE .425, EX .420, 112*lSA, Duration @.050 INTAKE .261, EX .258.....41 degrees overlap.

DRE Racing shaft rockers, 1.8 ratio

RHS 235 heads setup for GEN 2, SEE LINK
https://ls1tech.com/forums/parts-cla...-run-pics.html

SCAT/PROBE #1202-10067 Forged H beam rods with ARP half head bolts(bolts themselves were $90)

SCAT/PROBE #1302-13724 .030 forged dome pistons, 12.7 compression with 64 CC head

SCAT/PROBE#1302-12336 .030 forged flat top piston, 11.3 compression with 64 cc head

SCAT/PROBE 4340 forged 3.750 stroke crank, knife edged, balanced.

MELLING # M155HV, blueprinted, safety wired, hardened shaft, ARP stud, Canton pickup bolted on.

CROWER solid roller lifters, 2 sets
#66290 assembled but never run
#66292 dyno time only

SCHUBECK composite roller lifters, no pin the roller runs on a film of oil....HIGH DOLLAR, these were $1100 when purchased.

****ABOUT THIS BLOCK****

The lifter bores have been cut and notched for the Schubeck lifters, they can be bushed to run the Crowers or any conventional lifter, I confirmed this with my machinist if you don't want to run the Schubeck lifters.

Read about the lifters here

http://schubeckracing.com/index.html

This is about $12,000 worth of stuff here, Buy it all for $7500

E mail

Speedadikk@yahoo.com

or PM me.


No tire kickers, would like to see someone finish this thing. Open the combustion chambers a little, put the flat tops in, bolt on a 88mm blow through turbo and LOOK OUT.

If I cant sell it together after a while I will part it out.

RealQuick

iTrader: (14)

If you part it out I'd be interested in the valve covers.

Its Slo

iTrader: (6)

Bump for ya buddy. This is Ted that had the orange coupe a couple years ago. Sorry about your dad

FASTFATBOY

iTrader: (23)

Thanks.