WTT my cam for yours
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Apr 2012
Location: Bargersville, IN
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
WTT my cam for yours
I have a TR 230/224 .575/.563 111 lsa "Reverse Split" cam I'd like to trade for something a little bigger. I'm looking for something around the size of an MS3. Unsure of the miles on the cam since I bought it in the engine. The car had under 80K on it and I doubt the cam has too many. I'll have pics when I pull it this weekend, I just wanted to gauge interest on maybe trading before I go shopping and sell this one straight out.
#2
TECH Fanatic
iTrader: (9)
Join Date: Apr 2012
Location: Georgetown, Tx
Posts: 1,053
Likes: 0
Received 0 Likes
on
0 Posts
That's a cool cam with a great torque curve and you want to go to the complete other end of the spectrum to the Donkey D? Power won't come on until 4500 or so, and then you'll spin the tires off the thing! Not saying something bigger would be cool, just sayin' there's a middle ground and the MS3 isn't middle of the road. Also, if you bought the car and aren't sure of the heads and clearances, you could run into PTV issues. Might want to get in touch with Pat G, and have a him spec a cam for your goals. The reverse split is a pretty cool cam design! Great low end, with power throughout the rev range!
Check out this post on Gen III. internal Engine Forum:
https://ls1tech.com/forums/generatio...side-coin.html
May change your mind, or go bigger with the reverse split.
Check out this post on Gen III. internal Engine Forum:
https://ls1tech.com/forums/generatio...side-coin.html
May change your mind, or go bigger with the reverse split.