Kunz111

Category: Accessories
Price: $80
Part Fits: 93-02 Chevrolet Camaro
Location (State): MN
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine

Demodding my LS1 right now as I have different plans for my FC, and FD. It is a LS1 out of a 2000 TA that has a H/C/I set up that made 452 rwhp and 405 rwtq on a dynojet dyno on E85. Here are the following mods

PRC LS6 stage 2.5 heads from texas speed-1000. SOLD
Magic Stick 3 from texas-300 SOLD
fast 92 ported to 95 with PTM 95 throttle body-1000
LS7 lifters-100
Harland Sharp rocker arms-200
texas speed chromemoly pushrod 7.35-80
42 lb injectors-300
fast fuel rails-175
Texas speed front coolant pipe with custom rear made to fit fast intake-75

All parts have 1200 miles on them, I do have a dyno video and graph to prove numbers. Here is a idle video of when I first got it running


Here are some engine bay pictures

Kunz111

bump it up

plum krazy

iTrader: (4)

Pmed you

Kunz111

All pms relied too

Kunz111

cam sold

crankwalkin

iTrader: (2)

Did the rockers fit under the stock valve covers? Are the 1.7 or 1.8 ratio?

crankwalkin

iTrader: (2)

Also, just curious, it looks like your running the heat sink coils? And they are bolted directly to the valve covers? Where did you find them? I ended up modifying a set of stock valve cover to allow me to bolt my coils directly to them.

AndersonsSS01

still have the injectors?

ws6guy27

iTrader: (31)

Can I see pics of fast front coolant lines

Kunz111

I never used these rockers with stock valve covers, but I would imagine they will. They are stock ratio rockers. They valve covers that you see in the pic are holley valve covers that I got from summit. They look awesome and are affordable

here they are http://www.summitracing.com/parts/hly-241-91/overview/

As of right now the fast, throttle body, injectors, rails, and coolant pipe are pending payment.

crankwalkin

iTrader: (2)

My original plan was to run the Holley valve covers but everything I found said the heat drink coils wouldn't work on them, so I made my own cost about $40 in materials plus a little time. Turned out great, too.

Could you pm me some pictures of the rockers and a part number?