F.A.S.T. Intake and Throttle Body - LS1TECH - Camaro and Firebird Forum Discussion

02-05-2014, 06:43 AM

#1

Red98C5

On The Tree

Thread Starter

Join Date: Jan 2002

Location: Brick, NJ

Posts: 120

Likes: 0

Received 0 Likes on 0 Posts

F.A.S.T. Intake and Throttle Body

Category: Engine - Intake/Fuel
Price: $770
Part Fits: Corvette
Location (State): NJ
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine

I have a F.A.S.T. Intake and 90mm GM throttle body for sale that I took off my 2003 Corvette last week. I am selling the car but as there seems not to be any interest in a solid 10.8 car that is fully streetable and passes NJ Inspection, averaged over 23 mpg on a trip to Texas last April, and has the full powertrain built only 3500 miles ago, so I'm removing all the speed parts. The manifold is a 90/92 version (the manifold was installed at ECS) and as far as I can tell it is not ported. The throttle body is a GM unit put on at the same time and has the "plug-n-play" harness so that no wires were cut when installing the larger and different plug throttle body. This makes a super fast and clean install on a car with the smaller factory throttle body. This setup also does not require a special fuel rail if your installing it on most, if not all LS1 engines, which is another cost and time savings.

If somebody is interested in the manifold only, just make me an offer on it alone. I have it listed on Ebay, item 281258423101 so it may be sold at any time, and if your interested it's best to email me, although a PM will work as well.

I tried to post pictures multiple times here but they would not go, and they are the same photos that show in the Ebay ad, so if you want to see it just look at the Ebay listing.

Reply Like