LS1SpeedAddict

iTrader: (9)

Category: Engine - Exhaust
Price: $1800
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): AL
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4
LS Engine?: Fits LS Engine

Custom Built Stainless Fender Exit Headers


All 2 ¼ primaries into 4” collector with mufflers built in, 4” v bands with stainless extensions, can be used with bull horns if desired. Collectors can be slipped off for easy header removal. Fire wall modifications required to use these. They were built to use factory steering location but may require race steering shaft and or column. I have 4 wide band bungs welded in different locations to get different AFR samples. All welds are top notch.


I had these on my blower car and made over 1500hp with them. I have no doubt they are good for more but I’m switching to turbos, so these have to go unfortunately. These also made my car extremely loud, usually one of if not the loudest cars at the track. These would work perfect on a bad *** nitrous setup also.
Cost $2400 to have made, $1800 obo

Video to give an idea of sound, these were back before we ran fast with the car.



Pics on and off of car


















I will also have a bunch of other parts for sale, so if anyone is interested in blower parts, F1X, Gear drive, Intercooler, charge pipes, Injectors etc. let me know.

javier1730

iTrader: (16)

This is what i've been looking for, i which i had the funds to get them. GLWS
If the price goes down i might be interested.

LS1SpeedAddict

iTrader: (9)

To the top

Blown06

iTrader: (32)

Man, I would be very interested in these, but don't know how they would fit my truck. If there was a way I could dummy them up.............not sure how we could work that out???

LS1SpeedAddict

iTrader: (9)

What does your engine bay look like? Where are you located?

Blown06

iTrader: (32)

Here are the best pics I have without all the other **** on it. I'm in Houston Texas.

Blown06

iTrader: (32)

I think the issues would be, will they clear the stearing shaft and are they high enough to clear the frame rail and are they swept forward enough to stay out of the cab.

LS1SpeedAddict

iTrader: (9)

I think there is a good chance all three could be a problem. The frame and firewall has to be notched for them to fit in an fbody.

LS1SpeedAddict

iTrader: (9)

Price dropped to $1700. Bad *** headers, I wouldn't be selling these if I could still use them.

fuel

iTrader: (13)

message sent

LS1SpeedAddict

iTrader: (9)

Did you send a PM? I didn't get anything

LS1SpeedAddict

iTrader: (9)

Sold!