Sheet metal intake manifold flanges (aluminum) and ITB's
#1
Sheet metal intake manifold flanges (aluminum) and ITB's
Category: Engine - Intake/Fuel
Price: $200
Location (State): AL
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Okay so i have two sets of throttle bodies (8 throttle bodies total)
plus a set of aluminum intake flanges.
i did a ton of research on this setup and how to make it and here is the run down.
These throttle bodies have injector holes already built into them which will allow for you to spray water-meth or i suppose you could even get NOS system to work to.
they each have vacuum lines running off of them so you can easy plum them into a vacuum block. also they can be pulled apart and have a small bar put between them which you can use to hook up your throttle cable.
flanges are all cut by water jet and matched my heads awesome! although casting can very with gm heads so you might have to do a little porting depending on your setup.
I am asking 200 shipped anywhere in Canada or US. but i will also take trades so let me know what you have. could always use a new oil pump or timing gears and chain. but open to anything because at the end of the day as long as it helps me finish my build (cash or parts) i am sure we can make a deal.
last two photos are mock-ups of my idea made with steel.
I also have a set of very pretty center bolt valve covers which dont fit my heads i would like to get 100 bucks shipped for (last photo)