silverLSWON

iTrader: (16)

Category: Drivetrain
Price: $2000
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): PA
Item Condition: Used
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4
LS Engine?: Fits LS Engine

I have a moser 12 bolt for a 93 to.2002 f body, camaro, trans am, firebird. It's has almost every option from moser. The current gear ratio is 4.56 but I have a brand new set of motive 4.10s with a timkin bearing install.kit. it's a full spool, rear end aluminum girdle, powder coated hamertone silver, billet pinion yoke, 33 spline axles, welded lower control arm relocation brackets. It currently has 98 to 02 rear brakes (only backing plates are included). Its stock width as well not shortend. 4 channel abs..Price is 2000.00 with the 3 inch lingenfelter aluminum drive shaft or 1800 without. Located in pittsburgh. My number is
412 651 1038
call or text... also rear end is still in car but I can have it out in a few hours. Thanks for looking!

poltergeist 02

iTrader: (65)

Pm sent!

silverLSWON

iTrader: (16)

Bump.....

silverLSWON

iTrader: (16)

Bump...

silverLSWON

iTrader: (16)

Bump...

poltergeist 02

iTrader: (65)

I am starting to consider just buying this and say F the abs.

silverLSWON

iTrader: (16)

Honestly, my car is a 3 channel and I ran this rear. I didn't care about abs over the strength. I swear I was the only 3 channel f body. Every one I see is a 4 channel lol

silverLSWON

iTrader: (16)

If it doesn't sell then I'm putting a wave trac 35 spline diff In it.

stealth355tpi

I had the same issue, I bought a 4 channel rear but needed a 3 channel. I actually found a write up on here to drill and tap the pumpkin for the sensor. Free bump for ya tho.

McNasty

iTrader: (1)

Would you ship this/any idea how much it would cost? Awaiting a tax return but it should be here any day now, very interested.

silverLSWON

iTrader: (16)

i thought about converting it but I never priced out the reluctor for the diff. Thanks for the bump!

I will ship but I'm not doing the homework for shipping prices. It needs crated which I will do. It can be picked up at my business which saves a little on shipping.

Stuinkuwait

iTrader: (3)

Happen to be selling the lca / phb as well ? I haven't really considered a aftermarket rear but maybe I should. running a 500 horse ls1 stick. Where are you in Pgh?

SSdreamz

iTrader: (3)

this still for sale? and the driveshaft was this to a m6 or a4 car