P1SC Procharger Kit and extra parts--price drop!
#1
P1SC Procharger Kit and extra parts--price drop!
Category: Engine - Power Adders
Price: $3300
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): MI
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4
LS Engine?: Fits LS Engine
SOLD!
I have a pretty complete Procharger p1sc kit, as well as a few extra parts.
Some parts are new some are brand new. All parts have been purchased from this forum, or from Bob at Brute Speed.
I have not installed or ran this kit myself, as I have directed my attention towards selling this kit and my 99 TA, and doing an LS swap in a 1951 2 door coupe.
The P1 head unit is in pretty good shape, its used and serial number is 56744. Currently has a 6 rib 3.60 pulley mounted to it.
Has twin intercoolers and all piping and mounting brackets/hardware needed, black procharger blow off valve. Metal Plenum is in good shape, a couple scratches on it.(all used)
16" Zirgo Blue fan part number ZRG16, mounted in the Procharger 2 piece fan mount ---All brand new
Standard inlet hat with the large K&N cone filter--used
small K&N blow off filter--new
60# Siemen's deka injectors ((used)), all work perfectly
Also will add in a printed copy of the installation guide
$3300 or best
OTHER STUFF:
Brand new ATI Super damper and ATI pinning kit, with 2 pins--$500
Stock lid top piece from 99 Trans am--$30
8 rib pulleys: 4.5 and 3.85 --$55 each
All is available for pickup or shipping, at your expense. Located in Lake Orion, MI, 48362
**I need everything gone asap to get going on the new project so everything is best offer as well!
Additional Photo's will be uploaded later
Last edited by Fst_Byrd; 08-24-2015 at 07:49 AM. Reason: sold!
#6
Yes needs fuel system and obviously a tune...
Does not include belt, horn relocation bracket, cruise control relocation bracket, I have most of the hardware, but the kit may need random bolts,washers, etc that are called for during installation.
The head unit currently has a 3.60 6 rib pulley on it, I planned on going to 8 rib, so if your going to do a 6 rib setup, then you would need crank pulley for that.
If your looking to do 8 rib, I have the pin kit, crank pulley and ati balancer for sale separatly