HioSSilver

iTrader: (8)

Category: Drivetrain
Price: $2500
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): VA
Item Condition: Brand New
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6, LT1/LT4, Small Block, Big Block
LS Engine?: Non-LS Part

Mwc rear here with a stock 350 posi carrier. This is a short tq arm set up and the rear was made 1.5" narrow per side for 3" total so you can run the deep dish style wheel with it. It has 31 spline axles and 98-02 rear brakes to go with it. It can fit a 4gen or a 3rd gen fcar that way. The rear housing /axles/ bearings for the rear are brand new never run. Tq arm and mount was used very little. I also have a set of 3.89 i could let go with it. $2500 obo.

HioSSilver

iTrader: (8)

Bump!!!

SwampWS6

iTrader: (7)

Bump for a good deal! GLWS

HioSSilver

iTrader: (8)

Thanks for the bump swamp! Bumpin again

Boo"SS"t

iTrader: (2)

Wow! that's a great deal and I really need a rear end, but why are you so freaking far. Would you ship? or meet halfway? I'm in Wilmington, Oh. zip code is 45177.

HioSSilver

iTrader: (8)

I have no problem meeting someone with it. I could also ship it but that is a bit of a pita.

TonyMontana88

How much without the brakes?

HioSSilver

iTrader: (8)

Idk....pm me a offer with out the brakes. But in all honesty for the little extra for the brakes it's handier to have the brakes unless you have another set.

TonyMontana88

Are they stock brakes or aftermarket? I do have a set of stock brakes already.

HioSSilver

iTrader: (8)

Stock brakes which consist of backing plate and ebrake stuff that gets pressed on with the axle bearings. Or you can do what i did and make them removable.

Backyard_Nova

what back spacing wheels are you running with this rear? interested if a 4.5 back spacing wheel will work. where at in va?

HioSSilver

iTrader: (8)

All pm's replied at this point


Backyard I have never ran this rear housing. It is brand new. I think 4.5 bs would probably work with it. I know a 5.5 bs with a oe width rear leaves plenty of room on the inside.

TonyMontana88

By it being cut 3" will this work with a non-mini rubbed car you think?

HioSSilver

iTrader: (8)

For sure.



Sale pending

HioSSilver

iTrader: (8)

Sold....