LS7 heads and misc. parts
#1
LS7 heads and misc. parts
Category: Racing Parts
Price: $123456
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): TX
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
Previous deal fell through, so I'm making a new post. Here's all the details.
New, never ran LS7 heads ported by FRH.
Stock titanium LS7 intake valves that have been tumble polished by FRH / Del West.
Stock lash caps for the intake valves
Manley stainless steel solid stem exhaust valves
New spring seats
New valve seals
CHE bronze guides
Rear steam ports have been drilled and tapped, and -4 fittings have been installed
The pushrod holes have been enlarged so they can accept a 1/2" pushrod.
Heads have been machined for shaft rockers. Stock rockers can be used with a rocker stand from All Pro, MAST or TFS. They're about 100$ for the set.
70cc chambers
Flow numbers
Intake Exhaust
0.200 154 110
0.300 249 195
0.400 310 215
0.500 357 235
0.600 382 244
0.650 390 245
0.700 395 257
0.750 418 269
I also have...
2) Morel 5425 ultra pro solid lifters with the high pressure pin oilers - 600$
5) Custom cam. - 200$
Can be used as a solid roller or hydraulic roller, but you'd need roller rockers at the minimum due to lift. This cam was spec'd by Martin Smallwood with decent drivability in mind as I planned on driving this car quite a bit. This cam would have the characteristics of a 244 / 255 hydraulic roller after factoring in solid roller "low lash", which is set at .000 cold, and targeted at .008-.010 hot lash
250 / 266 duration on a 114+4 LSA
.400 INTAKE LOBE LIFT
.377 EXHAUST LOBE LIFT
.720 / .680 with 1.8 rockers
.680 / .640 with 1.7 rockers
110* ICL
118* ECL
6) ARP Gen IV head bolts - 100$
8) C6Z slave cylinder with... - 100$
36" speed bleeder line
Billet steel throwout bearing support
9) Manton adjustable pushrod length checkers and checking springs - 20$
10) Lingenfelter spring compressor - 50$
EVERYTHING IS NEW. I'VE ONLY MOCKED PARTS UP TO VERIFY P/V CLEARANCE, VALVE TRAIN GEOMETRY AND PUSHROD LENGTH.
I'll make a package deal for 3,700. That's everything listed, but the cam, head gaskets, ARP head bolts and valve train tool will be thrown in for FREE!!!
Last edited by SHovV; 03-21-2016 at 12:29 AM.