When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Category: Engine - Intake/Fuel Price: $75 Location (State): NC Item Condition: Used Shipping Information: Item Can be Shipped Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6 LS Engine?: Fits LS Engine
OK guys here is the deal. I have a nice collection of LS parts for sale. I have collected these over the last 4 or 5 years to build an LS but now I need the cash. Please send questions to mtopczewski83@gmail.com. Here is what I have for sale that is used:
LS6 flat top JE pistons with rings but no pins#245188 from a NASCAR K&N engine with 500 miles. .927 pin/1.314 comp HT. 2.5mm oil ring/1.2mm top/1.5mm second. $375 shipped.
Lunati connecting rods 60361251.
6.125 length, 2.100 big end, .927 small end. From an engine that had a slight amount of debris in the bottom end. Very light dings on a few rods. Nothing of major concern at all. Approximately 900 miles. $950 plus shipping.SOLD!
GM LS6 rockers with trunnion upgrade. I think the upgrade is the Comp cams kit. These are used about 900 miles. $200 shipped.
GM LS7 lifters used about 900 miles. $90 shipped.
Cloyes LS timing chain and cam gear only. Used about 900 miles. $75 shipped.
Now for the new!
Brand new GM LS6 intake manifold complete with stock injectors, rail, fuel pressure regulator, drive by wire throttle body. No MAP sensor. $800 shipped-SOLD
The last item will be available next week or the week after. It is a set of AFR 230cc Mongoose cathedral port LS2 heads. They are nearly new but needed one cylinder repaired after a bottom end issue. I am having the guides replaced in that cylinder, the deck slightly welded where the piston hit the deck and the valve job redone on the whole set and re surfaced. They will be assembled with 200 mile Ferrea 2.08 intake valves and 1.600 exhaust valves, 300 mile PSI1511ML beehive springs, 900 mile CHE steel retainers and steel locks. Pictures to come later this week or next. $2100 shipped.
I will try to reply to messages ASAP but I am not always able to get to my phone during the day. I would like to only accept payments by PayPal.
Is 475 a good price tbh more than I was willing to pay. I completely understand it's brand new. More than that and I'm better off buying fast intake or dorman. Again thank you all beautiful people on this site if 475 float your boat inbox me bud
I will also have a 6.0 iron block that I'm going to sell. I believe it is bored/honed to 4.020. I also think it is decked to 9.218-9.220? I'm not exactly sure because I bought it, dingle balled it, hot tanked it and put it up on a stand. I know it is decked more than stock I just cant remember how much. There is one or two broken bolts that should be easy to repair and slight water staining(not rust) in a few cylinders and lifter bores. I bought it like this so I have not done any of the machine work. Local pick up only please $400 obo.
05-02-2016, 08:47 PM
LS parts for sale! Lunati, GM, JE, Comp, AFR 
