WTB: part for a 10 bolt ASAP!!!
#1
WTB: part for a 10 bolt ASAP!!!
what i need is pictured below. there are two round metal plates on each side that act as spacers to keep the rear carrier from moving around. i snapped one in half while i was installing it.
here is a picture. obviously circled in red with the yellow lines is the part i need. if anyone has one lying around i will take it. i only need 1 but if you have two of them i will take them both. either post in here or PM me.
here is a picture. obviously circled in red with the yellow lines is the part i need. if anyone has one lying around i will take it. i only need 1 but if you have two of them i will take them both. either post in here or PM me.
#2
TECH Enthusiast
iTrader: (28)
Join Date: Apr 2008
Location: Grayson, KY 41143
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
Those are machined spacers, you probably need to mic your and see what the thickness is that way you can get another one relatively close or the same and don't throw off the setup of the carrier. Otherwise you get to do the ring gear setup all over again. Must have been a damn big hammer you were using.
#3
Those are machined spacers, you probably need to mic your and see what the thickness is that way you can get another one relatively close or the same and don't throw off the setup of the carrier. Otherwise you get to do the ring gear setup all over again. Must have been a damn big hammer you were using.
and it was a normal size hammer . the cold weather probably didnt help. i wasnt hitting it that hard either.