WTB: Complete LS3 intake, truck UD pulley, 1.5" WP spacers, LS3 MAF, + LOT MORE
#1
TECH Fanatic
Thread Starter
iTrader: (16)
Join Date: Jun 2008
Posts: 1,148
Likes: 0
Received 0 Likes
on
0 Posts
WTB: Complete LS3 intake, truck UD pulley, 1.5" WP spacers, LS3 MAF, + LOT MORE
Ok, so I need quite a few things for my project. I need:
LS3 intake/injectors/rails/throttle body (would prefer if the intake and tb were ported)
LS3 card style MAF and perhaps some type of pipe with the fitting machined or welded in
Mast L92 HO cam (NOT the SS cam)
Cam restrictor kit
Truck 25% underdrive pulley
F-Body bolt in LCA relocation brackets
3 point subframe connectors (prefer UMI)
Trans Am ebony dash and gauge bezel setup (everything I need to go into a Camaro)
104mm+ lid (I think the 104mm FTP is the biggest available)
AdFab gauge cluster pod
Corvette DBW pedal (08+ I believe)
1 1/2" water pump spacers
Mezerie electric F-body water pump
SJM ABS delete/line lock kit (have Hurst line lock already)
UMI Roto-joints
Koni single or double on-car adjustable rear shocks
Rear swaybar mounts for Moser 12 bolt (3" axle tubes I believe)
D585 truck coils (the ones with the heatsinks)
And I'm sure theres some stuff I'm forgetting, but thats more than enough for now. I know some of its a longshot, but what the hell? Can't hurt to see.
LS3 intake/injectors/rails/throttle body (would prefer if the intake and tb were ported)
LS3 card style MAF and perhaps some type of pipe with the fitting machined or welded in
Mast L92 HO cam (NOT the SS cam)
Cam restrictor kit
Truck 25% underdrive pulley
F-Body bolt in LCA relocation brackets
3 point subframe connectors (prefer UMI)
Trans Am ebony dash and gauge bezel setup (everything I need to go into a Camaro)
104mm+ lid (I think the 104mm FTP is the biggest available)
AdFab gauge cluster pod
Corvette DBW pedal (08+ I believe)
1 1/2" water pump spacers
Mezerie electric F-body water pump
SJM ABS delete/line lock kit (have Hurst line lock already)
UMI Roto-joints
Koni single or double on-car adjustable rear shocks
Rear swaybar mounts for Moser 12 bolt (3" axle tubes I believe)
D585 truck coils (the ones with the heatsinks)
And I'm sure theres some stuff I'm forgetting, but thats more than enough for now. I know some of its a longshot, but what the hell? Can't hurt to see.
Last edited by squee; 05-15-2011 at 01:54 PM.
#3
TECH Regular
iTrader: (39)
hey, i got one of these, i think it is well worth it. i resized the injectors for 200, ported the intake my self, and sold the fuel rail for 75. best deal, ive seen them go for 260 as well, but this shipped is still a great price. as it comes complete, with all the gaskets, they are pulled with low miles so they seal up great.
http://cgi.ebay.com/ebaymotors/2010-...Q5fAccessories
just an opinion
http://cgi.ebay.com/ebaymotors/2010-...Q5fAccessories
just an opinion