stockz

Just as it states, I am looking for something that fits with no mods to it, must be close shipping is to expensive I am in N.Ga SE. TN Pm me.

1961ba427

iTrader: (26)

Are you looking for an aftermarket rearend or a stock replacement?

SS SLP2

iTrader: (8)

I do have a complete 10 bolt from a 2000 camaro
complete all new bearing/Detroit Locker/3.73/AMA cover with stud kit/mos axles with reluctor rings/4 channel /backing plates,no rotors/welded tubes/weld on relocate brackets for lower control arm
500 + shipping or pick up.
unit housing has 74 k miles, 3 k miles on complete rebuild -locker, gear, bearings,axles
Pulled to add 9"

ps will add Lockwood traction action boxed lower control arms ( I will need to chk fit after I added relocate brackets? )
Johnny

FirstYrLS1Z

iTrader: (4)

for 3 channel ABS or 4 channel ABS & TC ?

stockz

Aftermarket or heavy duty rear, already set up for my car.

Thanks Johnny, I just bought Lowers, and will talk to my builder about your 10 bolt, Sorry I am not very technical, I do make over 500 to the tires, do you have any idea what this rear will hold? Oh and where are you, state wise? EDIT, I see now TX !

Not sure on the ans, but my car does not have TC.

Again thanks everyone.

FirstYrLS1Z

iTrader: (4)

No TC is a 3 channel.

SS SLP2

iTrader: (8)

I know the rear is good with the locker and mos axels. but if you are over 500/tires/and cutting good 60 ft'
I run 1.64'/tires/ NO way close to 500 ,

NO I would not trust it to last very long
good luck, Johnny

dozer504

iTrader: (2)

I have 3 series carrier wit eaton posi diff & 3.73 gm gears 70k on it pm your number so we can negotiate