WTB: RIP Procharger pulley
02-03-2016, 01:26 PM
#1
TECH Fanatic
Thread Starter
iTrader: (10)
Join Date: Feb 2005
Location: GA
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
WTB: RIP Procharger pulley Looking for a 3.4" RIP Procharger pulley...may consider a 3.25 as well. Looking for a 6 rib standard offset.
Thanks!
Thanks!
Last edited by YenkoST; 07-26-2016 at 12:14 PM.
02-10-2016, 01:03 PM
#4
TECH Fanatic
Thread Starter
iTrader: (10)
Join Date: Feb 2005
Location: GA
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
May be a little too small for me. The blower rpms would be at it's limit at 5950 with the 3.00 assuming no belt slip....I'll be running up to about 6700. 6700 would be around 69,000 rpms on the impeller which the max is 62000 on the D1SC.
I do wonder how much belt slip would slow down the impeller and if a 3.00 would be ok to run.
How much are you asking for it. I don't need an offset pulley...just one where the flange is even to the back of the pulley.
I do wonder how much belt slip would slow down the impeller and if a 3.00 would be ok to run.
How much are you asking for it. I don't need an offset pulley...just one where the flange is even to the back of the pulley.